The following servo settings are available on ArduSub 3.5.3 and QGroundControl v3.2.4-BlueRobotics-Rev6 or newer. This allows to clips to rotate so you can find the threaded hole in the Enclosure Cradle (4” Series) easily. It is easier to install these screws if the clips are not fully tightened until all screws are through the clips and threading into the Enclosure Cradle (4” Series). Install the M3x16 screws through the clips and into the Enclosure Cradle (4” Series). Mount the Electronics Enclosure to the frame using the M3x16 screws so that the dome is on the same side as the front center panels (the center panels without the 3 large holes). Apply silicone grease to the two radial O-rings on the O-Ring Flange (4” Series) that is attached to the Electronics Tray then install the Watertight Enclosure (4” Series) with installed Dome End Cap to the O-Ring Flange (4” Series).Ģ. Reinstall 4” Watertight Enclosure onto ROV with the following steps:ġ. 4 x M3x16 screws that were placed off to the side during disassembly.To reassemble your BlueROV2 electronics Enclosure, you will need the following parts and tools: Reassemble BlueROV2 Electronics Enclosure Technical, Order, or Shipping Questions?.A Smooth Operator's Guide to Underwater Sonars and Acoustic Devices.Technical Reference - Products and Software.Subsea Services - ROV/USV Service Provider Directory.Subsea Scholar - Research Paper Directory.Classroom Collaborators - STEM Directory.Control the Basic ESC with a Potentiometer and Arduino.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |